Lightwave Communications LDX-3232 Manuel d'utilisateur télécharger pdf (Page 75)

COMMAND REFERENCE

LDX-3232 Device-Dependent Command Reference

04_06 LDX-3232 59

CHAPTER 4



The LASer:ENABle:OUTOFF? query returns the value of the status outoff enable register

of the LASER operations.

Syntax Diagram

-where the response is the sum of the following:

Notes The enabled LASER events can be set by using the LASer:ENABle:OUTOFF command.

The LASER output status can be monitored by the LASer:EVEnt? query.

Examples "LAS:ENAB:OUTOFF?" -response: 1, means that Current Limit Condition will cause the

LASER output to be turned off.

"Radix Hex; Las:Enab:Eve?" -response: #H20B, means that all of the above conditions

will cause the LASER output to be turned off.

LASer:ENABle:OUTOFF?

FRONT PANEL

REMOTE

1 LASER Current Limit 256 N/A

2 LASER Voltage Limit 512 Output if out of tolerance

4 N/A 1024 N/A

8 Power limit (with output on) 2048 N/A

16 N/A 4096 N/A

32 N/A 8192 N/A

64 N/A 16384 N/A

128 N/A 32768 N/A

LAS

ENAB

OUTOFF

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 117 118

Pas de commentaire

Lightwave Communications LDX-3232 Manuel d'utilisateur Page 75