Lightwave Communications LDX-3232 Manuel d'utilisateur télécharger pdf (Page 46)

REMOTE OPERATION

Status Reporting

30 LDX-3232

CHAPTER 3



Output Off Register

The Output Off Enable Register allows you to determine that conditions and

events in the LDX-3232 High Compliance Current Source can cause the current

source output to be turned off. This reigster is configured in a manner similar to

the status reporting registers. However, the register output is not reported in the

Status Byte Register. Rather, it sets the hardware that controls the output

switching. The events and conditions that may be set to cause the current source

output to be turned off are shown in Figure 3.3.

The default (factory) settings for this register are shown in Table 3.3. These

settings are not affected by the *PSC (Power-On Status Clear) command.

Table 3.3 LDX-3232 Series Default Settings for Output Off Registers

0 - disabled 8 - N/A

1 - disabled 9 - disabled

2 - N/A 10 - N/A

3 - enabled 11 - N/A

4 - N/A 12 - N/A

5 - N/A 13 - N/A

6 - N/A 14 - N/A

7 - N/A 15 - N/A

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 117 118

Pas de commentaire

Lightwave Communications LDX-3232 Manuel d'utilisateur Page 46